Part 3 - Installation of Oracle Linux




Select "oralin11" and Click "Start"

Choose "Install an existing system"

Choose "Skip"

Click "Next"

Click "Next"

Select your keyboard (e.g. "French (pc)") and Click "Next"

Click "Next"

Click "Re-Initialize all"

Enter "oralin11" as Hostname and Click "Configure Network"

Select "eth0" and Click "Edit..."

Check "Connect automatically", Click "IPv4 Settings", Select "Manual" and Click "Add"

Enter "10.0.2.11, 255.255.255.0, 10.0.2.2" as Address, Enter "10.0.2.3" as DNS server and Click "Apply..."

NB: If you want to use "10.0.2.3" as DNS Server, you have to enable DNS Proxy or have to enter IP address of your DNS Server insteed of "10.0.2.3" (see Enabling DNS proxy in NAT mode).

Select "eth1" and Click "Edit..."

Check "Connect automatically", Click "IPv4 Settings", Select "Manual" and Click "Add"

Enter "10.1.0.11, 255.255.255.0" as Address and Click "Apply..."

Click "Close"

Click "Next"

Select your time zone (e.g. "Europe/Paris"), Check "System clock uses UTC" and Click "Next"

Enter (twice) "tototo" as Password and Click "Next"

Click "Use Anyway"

Select "Use All Space", Check "Review partioning" and Click "Next"

Select first disk and Click "-> (Add)"

Click "Next"

Select sdb free space and Click "Create"

Select "Standard Partition" and Click "Create"

Enter "/opt/sybase", Uncheck "sda", Click "Fill to maximum allowable size" and Click "OK"

Click "Next"

Click "Format"

Click "Write changes to disk"

Click "Next"

Click "Next"

Wait...

Click "Reboot"

Click "Device", Select "CD/DVD Devices" and Select "Remove disk from virtual drive"